Section Cut From The Countertop; Mounting - Smeg SI2741D Manual

power regime):
1. Follow the instructions in point 4 above.
2. Press the and
time.
• A beep will be emitted and the current
power level will be shown on the display.
3. Use the and
value.
• Press the and
time to save the new power value. The
appliance will switch off and you will have
to switch it on again in order to use it with the
new power limits.
• If you do not wish to save the changes,
simply do not use the display for at least 60
seconds.

Section cut from the countertop

Safety instructions for positioning and
installation
See General safety instructions.
• Installation can be carried out on various
materials such as masonry, metal, solid
wood or plastic laminated wood as long as
they are heat resistant (>90°C).
• Veneers, adhesives or plastic coatings on
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
• If the piece of furniture does not have the
required recess opening, either it will have
to be cut or masonry work carried out by a
competent technician.
• The minimum clearance between exhaust
hoods and the cooking surface must be at
least the distance indicated in the exhaust
hood installation instructions.
• The minimum clearances must also be
respected for the edges of the hob on the
back as indicated in the assembly
instructions.
• If the appliance is to be installed above an
oven, the oven must be fitted with a cooling
fan.
32 - INSTALLATION
buttons at the same
buttons to change the
buttons at the same
Appliance overall dimensions (mm)

Mounting

On top of oven built-in unit
The clearance between the hob and the kitchen
furniture or other installed appliances must be
enough to ensure sufficient ventilation and air
discharge. If installed above an oven, a space
must be left between the bottom of the hob and
the top of the appliance installed below.
On top of empty kitchen unit or drawers
If there are other pieces of furniture (lateral
walls,
drawers, etc.), dishwashers or fridges under the
hob, a double-layer wooden base must be
installed at least 20 mm from the bottom of the
hob to avoid any accidental contact. It must
only be possible to remove the double-layer
91477A906/C