Table of Contents
Advertisement
5 LPG G30/31 - 30/37 mbar
Rated heating capacity (kW)
Nozzle diameter (1/100 mm)
Reduced flow rate (W)
Pre-chamber (printed on nozzle)
Rated flow rate G30 (g/h)
Rated flow rate G31 (g/h)
6 LPG G30/31 - 37 mbar
Rated heating capacity (kW)
Nozzle diameter (1/100 mm)
Reduced flow rate (W)
Pre-chamber (printed on nozzle)
Rated flow rate G30 (g/h)
Rated flow rate G31 (g/h)
7 Town gas G110 – 8 mbar
Rated heating capacity (kW)
Nozzle diameter (1/100 mm)
Reduced flow rate (W)
Pre-chamber (printed on nozzle)
The nozzles not provided are available at Authorised Service Centres.
Electrical connection
See General safety instructions.
General information
Check the mains characteristics against the data
indicated on the plate.
The identification plate bearing the technical
data, serial number and brand name is visibly
positioned on the appliance.
Do not remove this plate for any reason.
The appliance must be connected to ground
using a wire that is at least 20 mm longer than
the other wires.
The appliance can work in the following modes:
• 220-240 V 1N~
The values indicated refer to the cross-
section of the internal conductor.
Fixed connection
Fit the power line with an all-pole circuit breaker
with a contact separation distance sufficient to
34 - INSTALLATION
AUX
1.05
50
400
-
76
75
AUX
1.10
50
400
-
80
79
AUX
1.05
145
400
0224/8
provide complete disconnection in category III
overvoltage conditions, pursuant to installation
regulations.
For the Australian/New Zealand market:
The circuit breaker incorporated in the fixed
connection must comply with AS/NZS 3000.
Connection with plug and socket
Make sure that the plug and socket are of the
same type.
Avoid using adapters, gang sockets or shunts as
these could cause overheating and a risk of
burns.
Section cut from the countertop
Safety instructions for positioning and
installation
See General safety instructions.
• Installation can be carried out on various
materials such as masonry, metal, solid
wood or plastic laminated wood as long as
they are heat resistant (>90°C).
• Veneers, adhesives or plastic coatings on
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
• If the piece of furniture does not have the
required recess opening, either it will have
to be cut or masonry work carried out by a
SR
UR3
1.75
3.9
65
100
500
1600
-
-
127
284
125
279
SR
UR3
1.80
4.00
65
94
500
1600
-
-
131
291
129
286
SR
UR3
1.75
3.8
185
340
500
1200
0224/2
0224/13
91477A898/A
Advertisement
Table of Contents
