Table of Contents
Advertisement
Quick Links
1.
INSTRUCTIONS FOR SAFE AND PROPER USE ______________________ 4
2.
INSTALLATION OF THE APPLIANCE _______________________________ 6
3.
GAS CONNECTION _____________________________________________ 8
4.
ADAPTING TO DIFFERENT TYPES OF GAS ________________________ 11
5.
FINAL OPERATIONS ___________________________________________ 13
6.
USE OF THE HOB _____________________________________________ 15
7.
CLEANING AND MAINTENANCE _________________________________ 17
8.
PROBLEMS AND CAUSES ______________________________________ 19
Thank you for choosing our product.
We advise you to read this manual carefully. It contains all necessary
instructions for maintaining unaltered the appearance and functional
qualities of the hob.
INSTRUCTIONS FOR THE INSTALLER: these are for the authorised
person who must carry out a suitable check of the gas system, install
the appliance, set it functioning and carry out an inspection test.
INSTRUCTIONS FOR THE USER: these contain user advice,
description of the commands and the correct procedures for cleaning
and maintenance of the appliance.
Contents
3
Advertisement
Table of Contents
Related Manuals for Smeg PVA96
Summary of Contents for Smeg PVA96
-
Page 1: Table Of Contents
INSTRUCTIONS FOR SAFE AND PROPER USE ______________________ 4 INSTALLATION OF THE APPLIANCE _______________________________ 6 GAS CONNECTION _____________________________________________ 8 ADAPTING TO DIFFERENT TYPES OF GAS ________________________ 11 FINAL OPERATIONS ___________________________________________ 13 USE OF THE HOB _____________________________________________ 15 CLEANING AND MAINTENANCE _________________________________ 17 PROBLEMS AND CAUSES ______________________________________ 19 Thank you for choosing our product. -
Page 2: Instructions For Safe And Proper Use
Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE HOB. - Page 3 Introduction DO NOT PUT PANS WITHOUT PERFECTLY SMOOTH AND FLAT BOTTOMS ON THE HOB GRIDS. DO NOT USE RECIPIENTS OR GRIDDLE PLATES THAT EXTEND BEYOND THE EXTERNAL PERIMETER OF THE HOB. THE HOB IS TO BE USED BY ADULTS ONLY. DO NOT LET UNSUPERVISED CHILDREN PLAY WITH THE HOB.
-
Page 4: Installation Of The Appliance
2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by an authorised persons. Clearance around the appliance must comply with the requirements of AGA601. (see 2.6) 2.1 Positioning The following operation requires building and/or carpentry work so must be carried out by a competent tradesman. - Page 5 Instructions for the installer The plug on the end of the supply cable and the wall socket must be the same type and conform to the current electrical system regulations. Check that the power line is adequately grounded. On the power line, install an omnipolar cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.
-
Page 6: Gas Connection
Instructions for the installer 3. GAS CONNECTION This appliance is suitable for installation with Natural Gas or LPG (propane). Refer to page 12 for the relevant burner pressure and appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulator supplied must be fitted to the gas inlet. - Page 7 Instructions for the installer 3.1 Room ventilation Caution – This cooker may only be installed and operated in rooms permanently ventilated in accordance with current regulations. For proper operation of a gas appliance it is essential for the air necessary for combustion of the gas to be able to flow naturally into the room.
- Page 8 REQUIREMENTS 1 Overhead clearances – (Measurement A) Range hoods and exhaust fans shall be installed in accordance with the manufacturer’s instructions. However, in no case shall the clearance between the highest part of the hob of the cooking appliance and a range hood be less than 600 mm or, for an overhead exhaust fan, 750 mm.
-
Page 9: Adapting To Different Types Of Gas
Instructions for the installer 4. ADAPTING TO DIFFERENT TYPES OF GAS Before any intervention, disconnect the power supply of the device. The hob has been adjusted for natural gas at a pressure of 1.0kPa. If used with other types of gas, you have to replace the nozzles and regulate the primary air to the burners. -
Page 10: Regulation For Lpg
4.2 Regulation for LPG Loosen screw A and push air regulator B to the bottom. With a 7 mm wrench, remove nozzle C and replace it with the proper one (follow reference tables for the type of gas to be used). The torque wrench setting of the nozzle must not exceed 3 Nm. -
Page 11: Final Operations
Instructions for the installer 4.4 Regulation of primary air Referred to distance “X” in mm. Burner Auxiliary Semi rapid Rapid 5. FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, the instructions in paragraph “4.1 Removing the top”. - Page 12 5.3 Arrangement of burners on the hob 5.4 Lubrication of gas taps With time it may happen that the gas taps get blocked and hard to turn. Clean them inside and re-grease them. This operation must be done by an authorised person. Instructions for the installer Burners Auxiliary...
-
Page 13: Use Of The Hob
Instructions for the user 6. USE OF THE HOB 6.1 Burner knob To light the flame, press and turn the knob anticlockwise to the large flame symbol. Adjust the flame by turning the knob to the area comprised between maximum and minimum marks. To turn off, set the knob to either 6.2 Lighting the burners Before lighting the burners make sure that the flame cap crowns are... - Page 14 6.3 Practical advice for using the burners For better use of the burners and lower gas consumption, use covered containers that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph “6.4 Diameter of containers”). When water reaches the boiling point, lower the flame so that it doesn’t overflow.
-
Page 15: Cleaning And Maintenance
Instructions for the user 7. CLEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 7.1 Cleaning stainless steel To keep stainless steel in good condition it should be cleaned regularly after use. Let it cool first. 7.1.1 Ordinary Daily Cleaning To clean and preserve the stainless steel surfaces, always use only specific products that do not contain abrasives or chlorine-based acids. - Page 16 Instructions for the user Preventive maintenance This appliance does not need any special maintenance. However, a few simple operations have to be carried out periodically to prevent malfunctioning: Burners: the burners must be cleaned periodically to ensure correct combustion; make sure that all the openings and flame ports are clean and free of obstacles, and that the burners rest firmly on their supports.
-
Page 17: Problems And Causes
Instructions for the user 8. PROBLEMS AND CAUSES Each of the following cases is caused by an abnormal operation of the appliance and should be dealt with by an authorised perso: please contact your local dealer or Service Center in case you detect any of these malfunctioning. - Page 18 Cod. 914771780...