Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Connect the Brewer Wiring (cont.)
Brewers With A Cord Set Attached -
12 Connect the power cord to the appropriate type of
electrical outlet.
WARNING: Connect the power cord to the
appropriate type and size electrical outlet. If the
electrical outlet is not compatible with the power
cord, have it upgraded by a licensed electrician.
Do not modify the power plug. Do not use an
extension cord. Do not use a power cord/plug that
is damaged.
Power Up the Brewer
13 Turn on the water supply valve.
14 Make sure that the circuit breaker supplying power to
the unit is on.
15 Turn the toggle switch on the back of the brewer to the
16 Determine if the brewer will be setup for one, two or
three batch mode. Find the appropriate label, included
with the brewer. The three batch label has LARGE,
17 Peel the protective backing off of the desired label
(UCM).
18 Go to the PROGRAMMING GUIDE section and
program the brewer for the correct model and batch
number.
IMPORTANT:
higher elevations, reduce the factory set operating
temperature (200°F/92°C) by 2°F/1°C for each
1000 ft./300 m of elevation above 4000 ft./120 m.
See PROGRAMMING GUIDE.
II1
D
Advertisement
Table of Contents
