Table of Contents
Advertisement
PROGRAMMING GUIDE
Non-Brew Programming Menu (cont.)
Display Brew Time - turns the display of the brew time during brewing On or Off. The factory default setting is
On. Once accessed, press
Display Messages - turns display of the message "Rinse Server Before Brewing" On or Off The factory default
setting is On. Once accessed, press
[QT] Display Timers [On/Off] - (some models, QT Alarm must be on) turns the quality timer countdown
display On or Off. The factory default setting is Off. Once accessed, press
setting. Then, press
QT Alarm On/Off - (Gemini models) turns the quality timer audio alarm On or Off. The factory default setting
is On for GEMS/GEMT models, Off for GEMIF and GEMX models. An audible alarm goes off when the quality
timer has expired. Once accessed, press
Satellite Color - (GEMX series models only) changes the color scheme of the quality timer LEDs on the
dispenser (satellite). Once accessed, press
to save, then press
Server Lockout - (GEMX series models only) turns the lockout feature On or Off. The factory default setting
equipped dispenser is in use (LOCKED appears on the display). Once accessed, press
desired setting. Press
Brew Button Programming Menu
Exit appears on the display. Press
default brew settings assume that the amber AFS spray head is installed.
Brew Button Prog
<-- Select -->
Press
Select Button...
<-- Select -->
Press BREW
Brew by Volume -
place, press the BREW button that is illuminated. When the desired volume is reached, press the same BREW
button again to stop the brew cycle and set the volume.
* Not applicable to TP1 series.
** This is the LARGE setting for TP1 series brewers.
or
to choose the desired setting, then press
or
to choose the desired setting, then press
to exit.
or
or
or
to choose the desired color to indicate "expired". Press
to save and exit.
to exit, then re-enter the Brew Button Program to program the next one. The
Brew by Volume
<-- Select -->
Select
Brew by Time
<-- Select -->
Select
to choose the desired setting. Then, press
to choose the desired color to indicate "fresh" (On). Press
Pre-Infusion
Pulse Brew
<-- Select -->
<-- Select -->
Select
Pulse Brew
Bypass On/Off
<-- Select -->
<-- Select -->
Select
continued...
to exit.
to exit.
or
to choose the desired
to exit.
to save and exit.
or
to choose the
Exit
<-- Select -->
Press
PG2
until
H
Advertisement
Table of Contents
