Table of Contents
Advertisement
A
A
| There are five control function keys available for adjustment of
contrast, brightness, saturation, hue and volume.
BRI
SAT
Except for the VOL key, all the control function keys provide the
y
U
possibility to act on picture contents.
Pressing such a key Causes a direct increase or decrease of the
A
corresponding actual value.
VOL
A short key-press results in a one step up or down of the corre-
y
sponding control function. Continuous pressing causes a fast
increase or decrease in steps of 10, for VOLume in steps of 3
The control value is made visible by means of a symbol and the
actual value between 050 and 200. This indication disappears
automatically from the screen about 7 seconds after the last key-
press or when you press CLEAR . When reaching a limit value, the
message
"VALUE OUT OF RANGE"
is displayed.
If you press CAL or PRE during control, the monitor
is set to
Calibrated or preset values. The calibrated values are 100.
Note that for volume there is no calibrated value.
Refer to the description
of the CAL and PRE command keys.
CON
(CONTRAST UP & DOWN)
—
9 CON
100
Key for contrast adjustment.
BRI (BRIGHTNESS UP & DOWN)
SAT
(SATURATION UP & DOWN)
Key for saturation adjustment.
——
@SAT 100 || yue (Hue uP a Down)
Ku
Key for hue adjusment. Only for NTSC.
KAHUE
100
VOL
(VOLUME UP & DOWN)
Key for volume adjustment. Only active when an Audio module or
an RF module is installed, or both together.
For the Audio module, VOL controls the loudspeaker output.
| vor
AVOL
100
For the RF module, VOL controls the XLR output signal.
Pressing CAL does not modify the actual loudspeaker output.
NOTE
Keys may be protected and only available after input of a
sultable password. Refer to the PRIVILEGE SETTING section
in this manual, on how to modify this.
When the keyboard is fully disabled, following keys are
available:
VOL CAL
PRE
VIDEO
RF FUNC
(for tabie).
CVM 3000 User Manual — Software 3.X
2-1
Control Function Keys
Advertisement
Table of Contents
