Table of Contents
Advertisement
Soft Focus Filter
The version 2 of the Ovation Rêve E-3 IP comes with the soft focus filter already pre-installed in the shutter
barrel, in front of the shutter blades and is being held by four filter holders.
•
To remove the soft focus filter, gently squeeze and slide the filter out from under the four filter
holders.
•
To replace the soft focus filter into the fixture, gently squeeze the filter and carefully slide it back
under the filter holders. Make sure to follow the orientation direction printed on the filter.
Soft focus filter
To keep the soft focus filter in good condition:
•
Ensure that no fingerprints are left on the filter, as this may cause the filter to heat unevenly and
eventually warp.
•
When inserting shutter blades into the light path, note that the heat is reflected back at the filter. The
deeper the blades are inserted, and the longer the fixture runs, the more heat gets reflected on to
the filter, causing it to warp and potentially adhere to the shutter blades.
•
If there is a protective film on the soft focus filter, it must be removed before use.
•
The standard filter frame must be used together with the fixture.
Lens Tubes
The following lens tubes are available for purchase:
•
19°, 26°, 36°, and 50° with gel frame (6.25 in/159 mm accessories)
•
5° gel frame (14 in/356 mm)
•
10° gel frame (12 in/304 mm)
•
14°, 15–30° and 25°–50° zoom gel frame (7.5 in/191 mm accessories)
12
Filter holder (x4)
Ovation Rêve E-3 IP User Manual Rev. 5
Setup
Advertisement
Table of Contents
