Battery Installation - CDN DW2 Manual

Note: In the following instructions, names of the control
buttons are shown in CAPS. Function information that
appears on the display is shown in BOLD CAPS.

BATTERY INSTALLATION

Replace batteries when LCD becomes dim. The Battery
Status Icon ( ) appears on the display when the batteries
need to be replaced.
1. Remove battery cover on the back with a small
Phillips screwdriver.
Note: Be careful to use a properly-sized screwdriver as a screwdriver
too large will strip the screwtops. Screws are small for sanitary reasons.
2. Install two new CR2032 batteries with positive (+)
side up.
Note: Mixing new and old batteries is not recommended.
3. Replace the battery cover.
OPERATING INSTRUCTIONS
A. On/Off
1. Press the POWER button (
turn on. The thermometer stays in Standby Mode
until turned off.
2. Press and hold the POWER button (
7-8 seconds to turn off. The Max and Min values
will be cleared.
Note: There is no auto-off. The DW2 must be manually powered off.
B. Temperature Scale
1. Remove battery cover on the back with a small
Phillips screwdriver.
Note: Be careful to use a properly-sized screwdriver as a
screwdriver too large will strip the screwtops. Screws are small
for sanitary reasons.
Note: This device could be sensitive to electrostatic discharge.
If electrostatic discharge or malfunctioning occurs,
please re-install the battery to reset this unit.
2
) for 5-6 seconds to
) for