Attaching Ferrite Clamps; Connecting Network And Power Sources - Polycom VVX 1500 User Manual

Attaching Ferrite Clamps

Connecting Network and Power Sources

Note
Your phone package includes two ferrite clamps. You must attach a ferrite
clamp to the network cable and to the computer cable (if you are connecting a
computer to your phone) before you attach the cables to your phone.
To attach a ferrite clamp to the network cable or PC cable:
Clamp a ferrite clamp around the cable.
>>
Before you connect the network cable to your phone, make sure you attach a ferrite
clamp to the cable (see
There are two ways to connect your phone to the network and a power source.
Your system administrator will advise you which method to use. (If your
phone is already connected to the network and a power source, go directly to
Connecting the Handset and Handset Cord
You can use one of the following methods:
• Connecting the Phone Using a Power Over Ethernet Source
• Connecting the Phone Using AC Power
Attaching Ferrite Clamps, above).
on page 1-8.)
Getting Started with Your Phone
1 - 5