Table of Contents
Advertisement
5Installation and connection
D o not install the appliance behind a decorative door
I n s t a l l a t i o n a n d c o n n e c t i o n
or the door of a kitchen unit, as this may cause the
appliance to overheat.
Electrical connection
Only licensed specialists may connect the appliance.It
is important that you comply with the requirements of
your electricity supplier.
Any damage arising from the appliance being
connected incorrectly will invalidate the warranty.
Caution!
Your appliance comes with the enclosed cable for
permanently connecting it to the mains electricity
supply.
Except in the event of damage, never remove the cable
from the appliance or replace it with another cable (with
or without plug).
Caution!
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
:
Warning – Danger of death!
There is a risk of electric shock if you touch live
components.
Always make sure your hands are dry when you
■
touch or hold the mains plug.
Only pull out the mains cable by taking hold of the
■
plug and removing the plug; never pull it out by the
mains cable itself, as this could damage it.
Never unplug the mains plug when the appliance is
■
in operation.
Please note the following information and ensure that:
Notes
The mains plug fits the socket.
■
The cable cross section is adequate.
■
The earthing system is properly installed.
■
The mains cable is only replaced by a qualified
■
electrician (if this is necessary).Spare mains cables
can be ordered from our after-sales service.
No power strips/multi-way connectors or extension
■
cables are used.
If using a residual current device, only use one that
■
bears the mark
.
z
The presence of this mark is the only way to be sure
that it fulfils all the applicable regulations.
The mains plug can be accessed at all times.
■
The mains cable is not kinked, crushed, modified or
■
severed.
The mains cable does not come into contact with
■
heat sources.
For the installer
An all-pole isolating switch with a contact gap of at
■
least 3 mm must be present in the installation circuit.
This is not necessary if the appliance is connected
by a plug that is accessible to the user.
Installation and connection
Electrical safety: The cooker corresponds to safety
■
class I and may only be used in conjunction with a
safety earth terminal.
A type H 05 VV-F or equally rated lead must be used
■
to connect the appliance.
Removing the appliance
Disconnect the appliance from the mains power supply.
:
Warning – Risk of electric shock !
When disconnecting the appliance from the mains, the
connections may cause residual voltages. Only allow a
professional to connect the appliance.
Adjacent units
Any adjacent units must not be made of flammable
materials. The fronts of any adjacent units must be heat-
resistant up to at least 90 °C.
Wall fixing
To prevent the cooker from tipping over, you must fix it
to the wall using the enclosed bracket. Please observe
the installation instructions for fixing the oven to the
wall.
Door lock
To prevent children reaching into the oven when it is
hot, the oven door is equipped with a lock. It is located
at the top of the oven door.
Opening the oven door
Press the lock upwards (picture A).
Removing the door lock
If the door safety lock is no longer needed or if it is
soiled:
Opening the oven door
1.
Unscrew the screw and remove the door lock
2.
(picture B).
en
11
Advertisement
Table of Contents
