Table of Contents
Advertisement
Installation and connection
Electrical connection
The appliance must be connected to the mains by a licensed
expert. The regulations of your electricity supplier must be
observed.
Any damage arising from the appliance being connected
incorrectly will invalidate the guarantee.
Caution!
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
For the installer
An all-pole isolating switch with a contact gap of at least
■
3 mm must be present in the installation circuit. This is not
necessary if the appliance is connected by a plug that is
accessible to the user.
Electrical safety: The cooker corresponds to safety class I
■
and may only be used in conjunction with a safety earth
terminal.
A type H 05 VV-F or equally rated lead must be used to
■
connect the appliance.
Wall fixing
To prevent the cooker from tipping over, you must fix it to the
wall using the enclosed bracket. Please observe the installation
instructions for fixing the oven to the wall.
Door lock
To prevent children reaching into the oven when it is hot, the
oven door is equipped with a lock. It is located at the top of the
oven door.
Your new appliance
In this section you will find information on the appliance, the
operating modes and the accessories.
General information
The design depends on the respective appliance model.
Opening the oven door
Press the lock upwards (picture A).
Removing the door lock
If the door safety lock is no longer needed or if it is soiled:
Opening the oven door
1.
Unscrew the screw and remove the door lock (picture B).
2.
Close the oven door.
3.
Explanations
1
Hob**
2
Control panel**
3*
Cooling fan
4
Oven door**
5*
Plinth drawer**
* Optional (available for some appliances)
** Details may vary depending on the appliance model.
7
Advertisement
Table of Contents
