Rectifying Faults Yourself; Maximum Operating Time; Replacing The Bulb In The Oven Ceiling Light - Siemens HL9R4T0 1U Series Instruction Manual

Trouble shooting
en

Rectifying faults yourself

You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 43
Fault Possible
cause
The appliance is Defective cir-
not working. cuit breaker.
Power failure Check whether the kitchen light
The time is flash- Power failure. Reset the time.
ing on the display.
The settings on The child-
the appliance proof lock is
cannot be config- activated.
ured. A key sym-
bol has lit up on
the display or
†'"" .
The appliance The appliance
door will not door is locked
open. A key sym- with the child-
bol has lit up on proof lock.
the display.
The appliance The appliance
door will not door is locked
open. A lock by the clean-
ing function.
symbol H has lit
up on the display.
After an operating The appliance
mode is switched has not
cooled down
on, œ is flashing
sufficiently.
on the display.
The appliance is Demo mode
not heating. The is activated.
colon is flashing
on the display. On
some appliances,
a š will also
appear on the dis-
play.
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
40
Notes/remedy
Check the circuit breaker in the
fuse box.
or other kitchen appliances are
working.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
The lock can be switched off in
the basic settings.
Wait until the cooking compart-
ment has cooled down and the
lock symbol H has gone out.
Switch off the appliance, allow it
to cool down and switch on the
operating mode again.
Briefly disconnect the appliance
from the mains (switch off the cir-
cuit breaker in the fuse box) and
then deactivate demo mode
within approx. 5 minutes by
changing the basic setting ™‚„
or ™› to ‹ . ~ "Basic settings"
on page 24
Error messages on the display
If an error message with "
e.g. - , touch the
"‹† „ƒ
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
error message and the E no. of your appliance.
~ "Customer service" on page 41

Maximum operating time

If you do not change the settings on your appliance for
several hours, the appliance will stop heating
automatically. This prevents unintentional continuous
operation.
When the maximum operating time is reached depends
on the various different settings that have been
configured on the appliance.
Maximum operating time reached
"‰ appears on the display.
Turn the function selector to the "Off" position. You can
configure new settings if required.
To prevent the appliance from switching off when
Tip:
you do not want it to, e.g. with an extremely long
cooking time, you should always set a cooking time.
The appliance will heat up until the set cooking time has
elapsed.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced.
Heat-resistant, 25 watt, 230 V halogen bulbs are
available from the after-sales service or specialist
retailers. When handling the halogen bulb, use a dry
cloth. This will increase the service life of the bulb. Only
use these bulbs.
:
Warning – Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to
1.
prevent damage.
Remove the glass cover. To do this, press the metal
2.
tabs to the side with your thumb (Fig. A).
Pull out the bulb (do not turn it ) (Fig. B). Insert the
3.
new bulb, making sure that the pins are in the
correct position. Push the bulb in firmly.
Refit the glass cover. When doing this, insert it on
4.
one side and press firmly on the other side. The
glass cover will click into place.
" appears on the display,
"
button. This will reset the
v