To Access The Basic Settings; Cookware Check - Siemens HL9R4T0 1U Series Instruction Manual

Restore to standard settings
™‹
‹ Individual settings.*
‚ Restore factory settings.
*Factory setting
--------

To access the basic settings:

The hob must be off.
Switch on the hob.
1.
Within ten seconds, touch and hold the
2.
for approximately four seconds.
The first four displays provide product information.
Touch the or symbol to view the individual
@ A
displays.
Product information
After-sales service index (ASSI)
Production number
Production number 1
Production number 2
Touch the 1 symbol again to access the basic
3.
settings.
and flash alternately on the displays and
™ ‚
appears as a presetting.
Touch the symbol repeatedly until the required
1
4.
function is displayed.
Then use the and
@
5.
required setting.
Touch the symbol for at least four seconds.
1
6.
The settings have been saved.
Leaving the basic settings
Turn off the hob with the main switch.
symbol
1
Display screen
‹‚
"š
Š†
.
‹ . †
symbols to select the
A
tCookware check
T his function can be used to check the speed and
C o o k w a r e c h e c k
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
Place a cold saucepan containing approx. 200 ml of
1.
water in the centre of the hotplate the diameter of
which matches the base of the pan most closely.
Go to the basic settings and select the
2.
Touch the
3.
display.
The function has now been enabled.
After 20 seconds, the quality and speed of the cooking
process will appear in the hotplate display.
‹
Check the result using the following table:
Result
The cookware is not suitable for the hotplate and will therefore
‹
not heat up.*
The cookware is taking longer to heat up than expected and the
‚
cooking process is not going as well as it should.*
The cookware is heating up correctly and the cooking process
ƒ
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.
To activate the function again, select the
Notes
If the diameter of the hotplate used is much smaller
■
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
■
section on ~ "Basic settings".
You can find information on the type, size and
■
positioning of the cookware in the section on
~ "Induction cooking".

Cookware check

or symbol. will flash on the hotplate
@ A A
en
setting.
™‚ ƒ
@ or A symbol.
25