Table of Contents
Advertisement
To collect data without saving it, press No Save Mode
NOT be saved, but screen shots can still be taken with the Camera button. These screen shots
get placed in the currently selected project.
If the line number is white (Figure 6-1), Press Start to enter data acquisition. All data collected
will be saved under this line number.
If the line number is shown in red (Figure 6-2), you will see the data preview on the right side of
the screen. If it's a long line, only the last part of the data will be shown. From this screen, you
will have the following options available:
•
View – press this button to review the currently displayed line.
•
Delete – pressing this will delete the line. It will prompt you to confirm before deleting.
Figure 6-2: Line Scan mode, showing a line that was previously collected
(Section
6.6.7). Any data collected will
52
Line Scan
Advertisement
Table of Contents
