SPX Radiodetection SENSORS & SOFTWARE LMX150 Operation Manual page 21

3. Getting Started
3.1 Powering Up
When the battery is first plugged in, the LED goes green for 5 seconds then disappears.
To start the system, press the red power button on the display unit. The LED on the front panel
will light up red.
Once boot up is complete, the colour of the LED will indicate the amount of battery power
remaining:
The first time you turn on LMX150™ FINDAR
3-1). A series of screen prompts will allow you to setup the language, units, date & time, and
some other options. You will have to do this again anytime you update the embedded software
(Section 14.6).
Every subsequent time the system boots up, you will see the main screen (Figure 3-2).
Figure 3-1: Display Unit
•
100% to 20% = green
•
20% to 10% = orange
•
10% to 0% = red
®
, you will need to configure the system (Figure
21
Getting Started
LED light
Power
button