Table of Contents
Advertisement
1.
If not already installed, install the LAN drops.
2.
Unfasten the front door latch and swing the door open (see
3.
Remove the right interface entry conduit landing plate to drill or punch holes (see
4.
Reinstall the interface entry plate and install the conduit.
5.
Route and install the LAN and other cables to the appropriate X-Slot cards. See
X-Slot communication bay locations.
6.
Close the door and secure the latch.
7.
Refer to the manual supplied with the X-Slot card for operator instructions
.
Figure 50. X-Slot Communication Bays
X-Slot Communication Bay 1
X-Slot Communication Bay 3
4 4 . . 1 1 0 0 I I n n s s t t a a l l l l i i n n g g a a R R E E P P O O S S w w i i t t c c h h
A latching-type Remote Emergency Power-off (REPO) switch can be used in an emergency to shut down the
UPS and remove power to the critical load from a location away from where the UPS is installed.
shows a REPO switch.
Eaton
®
Power Xpert
®
9395P-900 Installation and Operation Manual 164000501—Rev 12
UPS System Installation
Figure 24
).
Figure
Figure 44
X-Slot Communication Bay 2
X-Slot Communication Bay 4
39).
and
Figure 50
for
Figure 51
97
Advertisement
Table of Contents
