Assembling Leg Stand; Mounting Thelegstand Onthetable Sawbase - Craftsman TABLE SAW 315.22831 Owner's Manual

ASSEMBLING LEGSTAND(Continued)
• Align the two large holes on the brace and the legs.
Insert the cardage bolts. Add flat washers and hex
nuts and hand tighten. Repeat for the other short
upper brace. These are the front and back sets.
• For the sides, install a long upper brace on two
legs. Add hardware and finger tighten. Repeat for
the other long upper brace.
• Use the same steps to installthe lower braces.
Tighten all hex nutswith a 12 mm wrench.
• Place a hex nut and flat washer on each leveling
foot. install the levelingfeet from the bottomof
each leg with the boltspointingup. Secure with a
fiat washer and hex nut but do not tighten.
• Move the leg stand to desired location. Adjustthe
leveling feet with a 12 mm wrench, then securely
tighten the top hex nut.
_k WARNING: Do not lift the saw table without
help. The table saw base weighs approximately
95 Ibs. Hold it close to your body. Keep your
knees bent and liftwith your legs, not your back.
Ignoringthese precautionscan result in back
injury.
• Place the leg stand on the table saw base. Align
the holes in the table with the holes in the end
braces. Make sure the Craftsman label faces the
front of the saw (same side as height handwheel).
• Place a flat washer on each bolt and insertthrough
hole. Add a flat washer and a hex nut. Hand
tighten.
• Repeat for the three remainingholes. Tighten all
hardware with a 12 mm wrench. You may find it
helpfulto use two wrenches, one wrench to hold
the head of the boltand one to tightenthe hex nut.
Leave the saw upside downto add table exten-
sions.
HEXI, LEGSTAND
LEGSTAND SHOWN ASSEMBLED Fig. 8
MOUNTING THE LEG STAND ON THE TABLE
SAW BASE
See Figure 9.
• Take the followingfrom the hardware bag:
4 hex bolts(5/16-18 x 1/2 in.)
4 hex nuts (5/18-18)
8 flat washers (5/16 in.)
Note: This hardware was in the bag with hardware for
assemblingthe leg stand and levelingfeet.
• Place the saw table upside down on a smooth
surface, such as cardboard, on the floor.
Fig. 9
19 CRAFTSMRN" TABLE SAW315.228310