To Open/Close The Leg Stand; To Secure/Level The Saw - Craftsman 315.218061 Operator's Manual

[] Place thenylonnutintotherecessed holeontheback
ofthe height/bevel adjusting handwheel andholdin
place.
[] Slidethe handle, s crew, a ndwasher i ntotheholeon
theheight/bevel adjusting handwheel.
[] Using a flathead screwdriver, turnthe screwclockwise
andtightenin place.
[] Push theendcapbackinplaceontheendof the
handle.
TO OPEN/CLOSE (SET-UP/TEAR DOWN) THE
LEG STAND
See Figure 7.
To open (set-up) the leg stand:
[] Stejp_!: With the saw table on end and standing to the side,
use your left hand to pull the leg stand latch towards you.
[] Step__2:Once the leg stand is released from the table
saw base, ease the legs of the stand down.
[] Stejp__3: G rasp the upper leg support below the saw
cabinet.
[] Stejp__4_: Keeping your left hand clear of the leg stand,
pull the leg stand up until it locks into place.
[] Ste__5_:With the left hand firmly on the table tilt handle,
grasp the leg stand with your right hand.
[] Steps 6 and 7: Push the leg stand towardstheground with
your right hand and pull in the same direction with your
left hand until the table saw is in an upright position.
To close (tear down) the leg stand:
[] Step_ 1: Standing to the side of the table saw, grasp the
table tilt handle with your left hand.
[] Step_2: Tilt the table saw to your left and grab the leg
just below the leveling foot.
[] Step- 3: Lower the saw to the floor until it is balanced
on end.
[] Step__4:Using your left hand, release the leg stand
latch.
[] Steps 5 and 6: Once the leg stand is released from the
table saw base, ease the legs of the leg stand toward
the floor.
[] Step- 7: Lift the lower leg of the leg stand until it locks in
place.
TO SECURE/LEVEL THE SAW
With the leg stand open and the table saw resting on a
flat, level surface, the saw should not move or rock from
side to side. If the saw rocks from side to side, the leveling
foot needs adjusting until the leg stand is balanced.
[] Turning clockwise will lower the foot.
[] Turning counterclockwise will raise the foot.
16
SET-UP
2
TEAR DOWN
3
6
7
Fig. 7