Table of Contents
Advertisement
Assembly is best done in the area where the saw will be used. When you remove the table saw base, loose
parts, and hardware from the packing materials, check all items with the loose parts list and drawing. If you are
unsure about the description of any part, refer to the drawing. If any parts are missing, delay assembling until
you have obtained the missing part(s).
A. ASSEMBLY
OF LEG STAND, STORAGE
BRACKETS,
AND MOUNTING
TO SAW
ASSEMBLING
LEG STAND
See Figures 8 and 9
• Take the fottowing hardware from the teg stand
hardware bag:
24 carriage bolts (5/16-18 x 3/4 in)
4 leveling feet
32 fiat washers (5/16 in)
32 hex nuts (5/16-18)
Note: Remaining hardware from this bag is used for
mounting leg stand on the table saw base and
mounting storage brackets to upper brace.
•
Take 4 legs and 8 braces from loose parts.
•
Place an upper side brace inside two of the legs,
with the legs wide end up. (Upper side braces have
two large holes in each end.) Make sure the two
posts on the leg align with the small holes on the
brace.
Align the two large holes on the brace and the
legs. Insert the carriage bolts. Add flat washers
and hex nuts and hand tighten. Repeat for the
other upper brace. These are the front and back
sets.
•
For the side sets, install a upper brace on two legs.
Add hardware and finger tighten. Repeat for the
other upper brace.
•
Use the same steps to install the lower braces.
Tighten all hex nuts with a 12 mm wrench.
•
Place a hex nut and flat washer on each leveling
foot. Install the leveling feet from the bottom of
UPPER BRACE
BOLT
HEXNUT
CARRIAGE
BOLT
I
L
LEG
STORAGE
LOWER BRACE
BRACKET(S)
LEVELING FOOT--_'_
HEX
16
WASHER
NUT
Figure 8
CRAFTSMAN"TABLESAW315.228110
Hide quick links:
Advertisement
Table of Contents
