Craftsman TABLE SAW 315.22831 Owner's Manual page 32

REMOVING / REPLACING THE THROAT
PLATE
See Figure 41.
,_ WARNING: Make sure the switch is off, the
switch key is removed, and your saw is
unplugged. Failureto do so could result in
accidental starting, resultingin sadous personal
injury.
• To remove the throat plate, first loosen the screw in
the throat plate with a phillipsscrewdriverand lift
the front end. Pull it out toward the frontof the saw.
• To re-installthe throat plate, place It in the opening.
Push it towardthe rear of saw base to engage the
spdng clip.
Note: The keyslot in the throat plate willdrop over the
screw.
• Check that the throat plate is even with the table
top. If not, adjust the four set screwswith a 2
mm hex key. See the procedure in the Assam-
b/y section.
• Socure_y tighten throat plate screw. Do not allow
the throat plate to bow up above the table surface.
THROAT PLATE
KEYSLOT
SPRING CLIP
TABLE
Fig. 41
CRIIFI3MAN" TABLE SAW31tL_8310 32