Table of Contents
Advertisement
Introduction
1.4
Recommended Additional Equipment
Optional recommended equipment:
•
SensorHub Booster Pack
•
MSP430 FET
tool for code development, programming and debugging the device over JTAG
1.4.1
Sensor Hub BoosterPack Plug-in Module
Figure 5
shows the Sensor Hub BoosterPack plug-in module. This EVM has temperature, humidity, and
light sensors. There is demo firmware showing how to use each of these sensors. This board can be used
as a reference to develop custom functionality for digital sensors in an application.
1.5
Installation of the Software and Drivers
The most recent PC GUI and user's guide are available at www.ti.com/tool/RF430FRL152HEVM.
To install the PC GUI:
1. Download the
RF430FRL152HEVM Windows GUI
2. Run the executable and follow the prompts to install the software.
3. To run the application click on the Start menu, All Programs, then the Texas Instruments folder, then
the "RF430FRL152HEVM Application" and finally the "RF430FRL152H GUI Interface" program.
The USB drivers for the TRF7970AEVM are available from the
1.6
Update the EVM Firmware
The RF430FRL152HEVM comes loaded with firmware. However, updated firmware with fixes for the latest
known erratas is available. Download this firmware from www.ti.com/lit/zip/slac691, and load the
SensorHub example to have the same functionality as in the EVM.
6
RF430FRL152HEVM User's Guide
Figure 5. Sensor Hub BoosterPack Plug-in Module
Copyright © 2014–2018, Texas Instruments Incorporated
file to the PC.
Silicon Labs
website.
SLAU607C – December 2014 – Revised July 2018
www.ti.com
Submit Documentation Feedback
Advertisement
Table of Contents
