C) Automatic Set-Up Mode - MAX power COMPACT RETRACT 12 V Mechanical And Electrical Installation Manual

Table of Contents

B. Automatic Set-up Mode:

B.1 First go into Manual Mode following the procedure as described in section A above.

B.2 With system now in Manual Mode, push and hold down "On/Off", "Up" and "Down" push

buttons simultaneously for a period of 3 seconds. The system will now go into Automatic Set-

Up Mode with "On" LED on and "Up" and "Down" LED's flashing.

B.3 With the system in Automatic Set-up Mode the thruster will automatically go down for a very

short distance and the it will go fully up, then it will go fully down, find it's fully down position,

then raise, find its fully up position and switch off automatically.

B.4 To switch On/Off the system while in Normal Operation Mode, push up button until the thruster

reaches the maximum up position, then press the On/Off button and push the joystick to the

right position for one second.

C. Installation Mode:

C.1 First go into Manual Mode following the procedure as described in section A above.

C.2 Push and hold down "Up" pushbutton until unit double beeps, indicating that thruster is fully up.

C.3 With system now in Manual Mode and fully up, push and hold down "On / Off", "Up" and

"Down" push buttons, while pushing joystick to the right, simultaneously for a period of 3

seconds. The system will now go into Installation Mode with alternate flashing of "On", "Up"

and "Down" LED's following for a very short beep indication.

C.4 With the system in Installation Mode the thruster will automatically lower, find it's fully down

position, then raise find its fully up position, then lower and stop some distance from the

fully up position and switch off automatically.

C.5 The hull closing plate should now be fixed into place, as described in Section 3.6.

C.6

Once finished with fixing of hull closing plate the thruster will be ready for final set-up

procedure.

C.7

For final set-up of thruster go into Automatic Set-up Mode, as described in section B, to allow

system to do its final set-up. System will now be ready to be used in Normal Operation Mode

(see section D).

Table of Contents