Advertisement
1. Turn the "Power" On, the display will go into cycle mode as show
LCD DISPLAY OK
INIT START
WARNING: IF THE DISPLAY SHOWS BLANK SCREEN, TURN THE SYSTEM IMMEDIATELY
2. Check for the tone on the keypad buttons 0-9, # and *
3. Clear the memory.
REFER TO FUNCTION CODE 50 TO CLEAR SYSTEM'S MEMORY
4. Adjust the speaker volume, press # wait for dial tone, clockwise-decrease, counter clockwise-increase
refer to figure 2.1
5. Adjust the display intensity refer to figure 2.1
AeGIS 7000V
FLASH OK
COMPLETE . . .
DTMF OK
Welcome to Pach's
Page 12
Advertisement
