Cli Management; Login; Navigating The Command Line - Lantronix SISPM1040-582-LRT Manual

Lantronix
2

CLI Management

Follow the steps below to make a network connection for CLI command management.
1. Locate the correct DB-9 (RS-232) cable with a female DB-9 connector. RS-232 cable is used for connecting a
terminal or terminal emulator to the Managed Switch's RJ45 port to access the command line interface.
2. Attach the RJ45 serial port on the switch's front panel which used to connect to the switch for console
configuration
3. Attach the other end of the DB-9 cable to an ASCII terminal emulator or PC Com-1, 2 port. For example, PC
runs Microsoft Windows HyperTerminal utility.
4. At "Com Port Properties" menu, configure the parameters as below (see the next section).
Baud rate
Stop bits
Data bits
Parity
Flow control

2.1 Login

The command-line interface (CLI) is a text-based interface. You can access the CLI via either a direct serial
connection to the device or a Telnet session (default IP address: 192.168.1.77). The default username and
password to login into the Managed Switch are listed below:
Username: admin
Password: admin
After you log in successfully, the prompt displays as "<sys_name>#". It means you are an administrator and have
full privileges for configuring the switch. If not logged in as the administrator, the prompt will be shown as
"<sys_name>>", which means you are a guest and are not allowed the full set of CLI commands. Each CLI
command has its privilege level of 0-15.

2.2 Navigating the Command Line

To display
more
next page
continue
quit
parameters
syntax
available commands in table format
33757 Rev. J
115200
1
8
N
none
Press
-
Space
g
^C
?
??
Tab key
https://www.lantronix.com/
SISPM1040-582-LRT CLI Reference
Description
dash key
space bar
g key
Control C
Single question mark
Two question marks
available commands in table format
Page 6 of 272