Table of Contents
Advertisement
UM-D-005
DA14AVDDECTDEVKT Quick Start Guide
7. Now download Stack and COLA application to the target DUT
8. If you are using the carrier boards outside of EU region, change the DECT region accordingly by
using the HostApp tool (see
9. Now, Cola is disabled by default. In order to enable it, connect to the HID Interface by clicking on
"DUT Connection Manager" tab and then click on "HID" (see
Figure 19: DUT Connection Manager View (for HID)
10. Now enable Cola (marked blue in
11. To create a new project for the PP carrier board, follow the same procedure but change the
template type to "WAM PA Pp" in step 3.
12. Once both the FP and PP carrier boards are programmed, register PP to FP.
13. Long press the MUTE button to initiate the registration mode on FP until the red LED (D17) and
the orange LED (D13) start blinking simultaneously (1 sec on/1 sec off). See
User Manual
CFR0012
Figure 17: Download Stack/Cola Application
Figure
29). See section 4.1.
Figure 18: Open HostApp tool (See Toolbar)
Figure
20) and then Reset (marked red in
Figure 20: Enable Cola and Reset (See Toolbar)
Revision 1.2
15 of 22
(Figure
17).
Figure
19).
Figure
20) the board.
Figure
21.
18-Jan-2021
© 2022 Renesas Electronics
Advertisement
Table of Contents
