Table of Contents
Advertisement
UM-D-005
DA14AVDDECTDEVKT Quick Start Guide
4
Out of the box Use
The carrier boards are programmed and paired so they can be used directly out of the box. The
Audio Data Stack and Tour Guide application are already installed. This section uses the Tour Guide
application to explain how to set up the boards.
4.1
Verify DECT Region Setting
The development kit is configured in EU DECT mode. To avoid any violations, the carrier boards may
need to be re-configured for the actual region. Follow the steps below to change the DECT region
settings.
1. Open HostApp (location is "Workspace_AVD/Tools/") on your PC and connect the PC to the FP
or PP board via USB (use WinHID connection).
Figure 6: HostApp Screenshot for Changing DECT Mode
2.
Figure 6
presents the GUI of HostApp. The DECT mode can be changed by following the details
below:
a. Switch to "Production Test" tab (marked blue) and under "Project" browse to
"RtxProdTest.dll" (marked black).
b. Click the "SetDectMode" command on the left "Commands" column (marked green) and
enter your DECT region (for example, 0x1 = US_DECT) in the "Parameters" field (marked
red).
c. Click the "Execute" button (marked yellow), make sure that status in the "Output" is
"RSS_SUCCESS" (marked orange), and then power cycle or reset the module.
4.2
How to Set up
1. Power up the fixed part (FP) carrier board either via miniUSB cable or from a battery. When
power is supplied, the LEDs on the FP should light up, D5 red and D16 green, as shown in
Figure
3. Power up the PP in the same way.
User Manual
CFR0012
Revision 1.2
9 of 22
18-Jan-2021
© 2022 Renesas Electronics
Advertisement
Table of Contents
