Test Run - Grizzly G0637HEP Manual

Test Run

When the assembly is complete, test run your
dust collection system to make sure it operates
properly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 50.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run your dust collection system:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2.
Make sure all tools and objects used during
setup are cleared away from the machine.
3. Review Power Supply on Page 12 and con-
nect the machine to the power source.
4. Flip the main power switch at the lower
left hand corner of the control box (see
Figures 56) to (I) from (O).
Note: For the Model G0638, make sure the
EMERGENCY STOP button is popped out by
twisting the knurled knob clockwise.
EMERGENCY STOP
Button
Main Power
Switch
Figure 56. Control box (Model G0638 shown).
Model G0637/G0638 (Mfd. Since 04/12)
5.
6.
7.
8.
9.
ON/OFF
Button
Timer
Button
Press the ON/OFF button to turn the machine
ON. Make sure your hand stays poised over
the switch in case you need to quickly turn
the machine OFF.
Listen to and watch for abnormal noises or
actions. The machine should run smoothly
with little or no vibration or rubbing noises.
— If you suspect any problems, immedi-
ately turn the machine OFF and discon-
nect the machine from power. Refer to
Troubleshooting on Page 50 to identify
and fix any problems.
—If you cannot solve the problem with the
use of the Troubleshooting guide, contact
our Tech Support at (570) 546-9663 for
assistance.
Press the TIMER button on the control box
and cycle through each of the times to make
sure the indicators light.
Press the TIMER button on the remote con-
trol and cycle through the times in the same
manner as Step 7.
Toggle the ON/OFF button on both the con-
trol box and the remote control to make sure
they are working properly.
Note: For proper operation, the impeller
inside the blower housing must be rotating
counterclockwise. Since the motor and impel-
ler are directly connected, you will verify in
the next step that the motor is rotating in the
correct direction.
Keep in mind that if the motor is rotating in
the incorrect direction, the dust collector will
still operate but with drastically reduced per-
formance.
If any part of your body contacts the spin-
ning impeller, severe cutting or amputation
injuries could occur. Always keep well away
from the impeller and never use any tools
near the impeller when the machine is con-
nected to power.
-33-