Grizzly G0637HEP Manual page 6

Assembly
The HEPA cyclones are assembled largely the
same way as the regular cyclones, but with the
HEPA filter components being installed in place of
the regular canister filter assembly. To assemble
your HEPA cyclone, open the Assembly section
in the Owner's Manual and follow those steps only
when specified below.
To ensure the integrity of the HEPA filtration
system and prevent fine dust from leaking
out before it reaches the filters, we strongly
recommend using a general-purpose sili-
cone sealant on all mating surfaces dur-
ing the assembly process. For those com-
ponents assembled with a rubber gasket
between them, apply the sealant evenly on
both sides of the gasket before assembly.
To assemble the G0637HEP:
1. Follow Steps 1–33 in the Assembly section,
beginning on Page 21 of the owner's manual.
In Step 13, replace original brackets (shown
in Figure 24 of the owner's manual) with
brackets provided (see Figure 1).
Figure 7. Dust collector assembled with provided
brackets and outlet gasket.
-6-
2. Follow assembly instruction Steps 14 –27 in
owner's manual.
3.
Position outlet gasket around opening on
blower housing (see Figure 7), then attach
outlet to blower housing (see Figure 8) using
(10)
and (10)
Figure 8. Blower housing and outlet attached.
4.
Assemble all three HEPA support leg
components (see Figure 9) using (8)
1" hex bolts, (16)
nuts. Then thread adjustable foot completely
into bottom of support leg.
Outlet
Gasket
Brackets
Provided
Figure 9. Assembled HEPA support leg
Model G0442HEP/G0601HEP (Mfd. Since 01/15)
⁄ " x 1" hex bolts, (20)
3
8
⁄ " nuts.
3
8
⁄ " flat washers, and (8)
3
8
Install Adjustable
x8
(comprised of three parts).
Model G0637HEP (Mfd. Since 01/15)
⁄ " flat washers,
3
8
Blower
Housing
Outlet
x10
⁄ " x
3
8
⁄ "
3
8
Foot Here