Grizzly G0637HEP Manual page 42

43. For each lower collection drum cylinders,
attach the casters to the bottom using (4)
16 hex nuts, (4) ⁄
3
8
lock washers (see Figure 38).
Figure 38. Dust collection drum casters installed.
44. Connect each upper and lower collection
drum cylinder with a collection drum clamp
and use (1) ⁄ "-18 x 3" hex bolt and (1)
5
16
⁄ "-18 hex nut to tighten the clamp (see
5
16
Figure 39).
Figure 39. Installing drum clamp around dust
collection cylinders.
-28-
3
" flat washers, and (4)
45. Install the rubber seal over the top lip of the
⁄ "- collection drum rim. Pay special attention
8
⁄ " to the direction of the seal, as shown in the
3
8
Figure 40.
Tip: To keep the seal in place, you can use
an adhesive applied to the rubber seal at
approximately 1" intervals.
Figure 40. Installing drum seal.
46. Install the drum lid latches on the upper part
of each collection drum assembly with (12)
#10-24 x
#10-24 hex nuts (see Figure 41).
Figure 41. Collection drum lid latch installed.
47. To prevent a vacuum leak in the collection
drums, use (12) #10-24 x
screws and (12) #10-24 hex nuts to plug the
holes in the lower half of the collection drums.
Model G0637/G0638 (Mfd. Since 04/12)
Seal
⁄ " Phillips head screws and (12)
3
8
⁄ " Phillips head
3
8