Test Run - Grizzly G0852 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following:
1) The main motor powers up and runs correctly,
and 2) the main motor shuts down correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run machine:
1. Clear all setup tools away from machine and
connect to power source.
2.
Lock casters so machine will not move.
Model G0852 (Mfd. Since 12/18)
3. To prevent tripping circuit breaker or sup-
ply fuse, connect machine to dust-collection
system and restrict airflow by partially closing
blast gates to limit motor amperage draw dur-
ing test run.
Note: If a dust-collection system is not avail-
able, restrict airflow by blocking one 4" port
on the dust inlet adapter with a cap or a piece
of wood.
4.
Stand away from intake port, then press ON
button on switch box (see Figure 30) to turn
dust-collection motor ON.
5.
Motor should run smoothly with little or no
vibration or rubbing noises. Press STOP
paddle to turn dust-collection motor OFF (see
Figure 30).
— If you suspect any problems, immedi-
ately turn machine OFF and disconnect it
from power. Refer to Troubleshooting on
Page 37. If you cannot resolve the prob-
lem, contact our Tech Support at (570)
546-9663 for assistance.
ON Button
STOP Paddle
Figure 30. Dust-collection motor ON button and
STOP paddle.
-21-