Bolt Torque & Tools Required - Yetter 5000-025B Owner's Manual

Important: Over-tightening hardware can cause just as much damage as under-tightening.
Tightening hardware beyond the recommended range can reduce its shock load capacity.
All hardware on the 5000 Devastator is either Grade 5 or Grade 8, unless otherwise noted. Grade 5 cap
screws are marked with three radial lines on the head. Grade 8 cap screws are marked with six radial
lines on the head. If hardware must be replaced, be sure to replace it with hardware of equal size,
strength and thread type. Refer to the torque values chart when tightening hardware.
The chart below is a guide for proper torque. Use it unless a specified torque is called out elsewhere in
the manual.
Torque is the force applied to the end of the handle or cheater bar, times the length of the handle or bar.
The following table shows torque in ft.-lbs. for coarse thread hardware.
INSTALLATION TOOLS REQUIRED:
- Pneumatic or electric impact driver
- ¾ & 15/16 size sockets
- 10" impact driver extension
- Ratchet
- ¾, 15/16, & 1 1/8 size wrenches
- 5/16 Allen Wrench
- Torque Wrench
10
BOLT TORQUE
Use a torque wrench wherever possible