Advertisement
BOLT TORQUE
Important: Over-tightening hardware can cause just as much
damage as under-tightening. Tightening hardware beyond the
recommended range can reduce its shock load capacity.
TM
All hardware on the Titan
Residue Manager is Grade 5 or Grade 8,
unless otherwise noted. Grade 5 cap screws are marked with three radial
lines on the head. Grade 8 cap screws are marked with six radial lines on
the head. If hardware must be replaced, be sure to replace it with hardware
of equal size, strength and thread type. Refer to the torque values chart
when tightening hardware.
The chart below is a guide for proper torque. Use it unless a specified
torque is called out elsewhere in the manual.
Torque is the force applied to the end of the handle or cheater bar, times
the length of the handle or bar.
Use a torque wrench wherever possible.
The following table shows torque in ft-lbs for coarse thread hardware.
5
Advertisement
