Configuration Chart; Installation Instructions - Altronix TROVE T1MK1F4D Installation Manual

page of 8

/ 8
Bookmarks

Altronix Trove Mercury kits are pre-assembled and consist of Trove1M1 enclosure/backplane with factory installed Altronix power supply/charger

and sub-assemblies. These kits also accommodate various combinations of Mercury boards for up to four (4) doors in a single enclosure.

Altronix

Model

Number

5A/

T1MK1F4

3.5

250V

5A/

T1MK1F4D

3.5

250V

5A/

T1MK1F4S

3.5

250V

5A/

T1MK1F4SD

3.5

250V

Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI and with all local codes and authorities having jurisdiction.

Product is intended for indoor use only.

1. Remove backplane from enclosure. Do not discard hardware.

2. Mark and predrill holes in the wall to line up with the top two (2) keyholes in the enclosure. Install two upper fasteners and screws

in the wall with the screw heads protruding. Place the enclosure's upper keyholes over the two upper screws; level and secure.

Mark the position of the lower two holes. Remove the enclosure. Drill the lower holes and install the two fasteners. Place the

enclosure's upper keyholes over the three upper screws. Install the two lower screws and make sure to tighten all screws.

3. Mount included UL Listed tamper switch (Altronix Model T112 or equivalent) in desired location, opposite hinge.

Slide the tamper switch bracket onto the edge of the enclosure approximately 2" from the right side (Fig. 1, pg. 2).

Connect tamper switch wiring to the Access Control Panel input or the appropriate UL Listed reporting device.

To activate alarm signal open the door of the enclosure.

4. Position Mercury access controller modules over corresponding spacers and depress onto

snap on spacers, Fig. 2, pg. 3.

5. Refer to the eFlow Power Supply/Charger Installation Guide for eFlow4NB,

and corresponding Sub-Assembly Installation Guide for ACM4(CB), PDS8(CB)

and VR6 for further installation instructions.

6. Mount backplane to enclosure with hardware.

Hardware:

Snap On Spacer

- 2 -