Operation With The Ir Remote Control Ir-46 - EuroLite AKKU MBT-3 Spot MK2 User Manual

Operation with the IR remote control IR-46

With the remote control, the integrated show programs in automatic or sound-controlled mode as well as
preset color selection can be set. The IR remote control will only work in stand-alone mode, it will not work in
DMX or slave mode Press the buttons repeatedly to switch between the programs. The display indicates the
current setting. When actuating a button, always hold the remote control in the direction of the sensor at the
unit's front or rear. A direct line of sight between the remote control and the sensor is required. The remote
control can be activated/deactivated in the system settings (I-EN).
Battery
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the right
and at the same time remove the battery support. For operation, one 3 V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support
Button
On/off
Automatic mode – auto programs
Sound-controlled mode – sound controlled programs
Increase speed of auto programs
--
Color presets (LC1-15) for the left LED
Color presets (MC1-15) for the middle LED
Color presets (RC1-15) for the right LED
Color presets (AC1-15) for all three LEDs
No function
35/44
Function
Au-01 – Au-09
SD-01 – SD-09
00149656, Version 1.1