Remote Control Ir-7 - EuroLite FLD-1508 User Manual

Color adjustment
In the color mode Colo, the LEDs can be adjusted for brightness. The device will constantly emit the color
adjusted.
1 Press the MENU so many times until Colo is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates the letter u for UV color and the corresponding brightness value. Use the
buttons UP and DOWN to adjust the desired brightness.
Total brightness
Menu diMM allows adjusting the total brightness for all stand-alone operating modes: Auto, Soun and Colo.
1 Press the MENU button so many times until diMM is indicated in the display. Confirm with the ENTER
button.
2 Use the buttons UP and DOWN to adjust the desired brightness (dI 1 = dark, dI 9 = bright). Confirm with
the ENTER button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAU is indicated in the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to the desired operating mode. The interconnected devices will now operate in sync.

Remote control IR-7

The device must be activated for remote control. For this, set menu item InFr to on. When actuating a
button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor.
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
Button Function
BLACKOUT
LEDs off
AUTO Automatic mode; program selection with (+)/(‒)
SOUND Sound control; program selection with (+)/(‒)
Strobe effect for automatic mode and sound control;
STROBE
flash rate setting with (+)/(‒)
SPEED Running speed in
SENSITIVITY
Microphone sensitivity; setting with (+)/(‒)
DMX DMX mode
MANUAL Color mode; select color UV
FADE Color fade mode
1-9 Total brightness; 1 = dark, 9 = bright
23/28
automatic mode; setting with (+)/(‒)
00120790.DOCX, Version 1.0