Operation With The Ir Remote Control - EuroLite LED KLS-902 Next User Manual

Operation with the IR remote control

The IR remote control allows convenient control of the integrated show programs in automatic mode or
sound-controlled mode, and the color mode with preset colors. The IR remote control will only work in stand-
alone mode, it will not work in DMX or slave mode Press the buttons repeatedly to switch between the
programs. The display indicates the current setting. When actuating a button, always hold the remote control
in the direction of the sensor at the control unit's front or rear. A direct line of sight between the remote
control and the sensor is required. The remote control can be activated/deactivated in the system settings.
Battery
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the right
and at the same time remove the battery support. For operation, one 3 V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
Button
On/off
Switch through automatic programs 1-20
Switch through sound-controlled programs 1-20
Pause / play
/ Set running speed for automatic mode
Color selection for color mode
1 –
—
Color switch / fade
No function
,
/ / No function
—
Function
32/40 00126630, Version 1.0