Annual Maintenance - Bellfires BEL VBMT-3NG-SB Installation Manual

Direct vent gas fireplace
Table of Contents

Advertisement

IMPORTANT:
It is essential that the appliance, the complete concentric fl ue system
(where possible) and the outlet are cleaned and inspected annually by
a certifi ed gas technician. The safe operation of the appliance will thus
remain guaranteed.
Maintenance consists of the following:
• Remove fi rst the embers, vermiculite granules and logs set from the main burner and
carefully clean these with a soft and dry brush. Do not use water !!
• Clean and inspect (visually) the main burner, pilot light, combustion chamber, fl ue
system and combustion air intake. Dust can be removed using a vacuum cleaner.
• Clean the glass on the inside of the appliance with glass spray or ceramic glass
cleaner. This also applies to the black mirror rear wall and side panels, if the
appliance is fi tted with these.
• After cleaning; Carefully replace the embers, vermiculite granules and logs set on
and around the main burner according to the installation directions in this instruction
booklet.
Do not place any embers, vermiculite granules or logs against the pilot light
burner. Make sure that the pilot fl ame can burn at all times freely over the
main burner. Only in this way is proper ignition of the main burner ensured.
Ignoring these directions could lead to a dangerous situation.
• Check the gas supply, fl ue system, and combustion air supply route for leaks.
• Check the correct operation of the gas regulator block, thermocouple circuit and the
ignition of the main burner.
• Check the gas inlet-pressure (both when the appliance is off and when it burns at
maximum) and the burner pressure.
• Check the complete concentric fl ue system including the outlet construction.
A camera can be used to inspect the whole length of the fl ue gas outlet and the
combustion air intake.
Also check that all connections are secure.
Bellfi res

ANNUAL MAINTENANCE

64
Installation instructions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vertical bell medium tunnel 3 lf

Table of Contents