Information About Priorities Between The Different Modes; User Settings; Choice Of Language Use; Backlight Setting - Supra Dalbeo WiControl 1022 Installation And Operating Instructions Manual

I
NFORMATION ABOUT PRIORITIES
BETWEEN THE DIFFERENT MODES
• Principle
In Comfort, Eco and Frost protection mode, only orders of the occupan-
cy sensor and those of the opened window sensor will be considered.
In Auto mode, the radiator can receive different orders coming from:
- 7 day and daily programme integrated (Comfort or Eco orders) ;
- Pilot wire 6 orders, if connected to a central control unit ;
- Opened window detector ;
- Occupancy detector.
In general, it is the lowest received order which prevails.
If an open window detection or an occupancy absence of more
than 72 hours is detected, switching to frost protection takes
precedence unless a load shedding order is present on the pilot
wire.
Special case of self-programming where the temperature level in
the room is decided according to the learning of the lifestyle and
the optimisation mode selected (Opti Comfort or Opti Eco):
- During the programmed passage in period Eco, if a presence is
detected in the room, it will be taken into account and the appliance
automatically switches to Comfort mode.
- During the programmed passage to the Comfort mode period, the
absence detection system is temporarily suspended (30 minutes).
• Examples
7 day and daily programming
+
Pilot wire 6 orders
= Eco
7 day and daily programming
+
Pilot wire 6 orders
+
Occupancy detector
= Frost protection
7 day and daily programming
+
Pilot wire 6 orders
+
Occupancy detector
+
Open window detector
= Heating standby mode
= Comfort
= Eco
= Comfort
= Eco
= Frost protection
= Eco
= Stop (heating standby mode)
= Eco
= Hors-gel

User settings

User settings
• Accès
Press several times on M until the
cursor is under . (User set-
tings) appears on the display. Press
OK to access the settings users.
Note: If you do not press OK, the
change of a setting is not taken
into account.
To manually exit a current setting,
press M. Otherwise, after a few
minutes and without pressing any
buttons, the device automatically
exits the current setting.
Schematic sequence of settings:
Selecting the operating language
mode Disconnecting
C
HOICE OF LANGUAGE USE
Select the desired language
1
with Minus or Plus.
: French
: English
To confirm and move to the next setting, press OK. To exit user
2
settings, press M for 3 seconds.
B
ACKLIGHT SETTING
Three back-light settings can be
set:
The default setting is L2.
L1 = Reduced display with low
brightness and backlighting when
a button is pressed or during occu-
pancy detection.
L2 = Reduced display with low
brightness and backlighting when
a button is pressed.
L3 = Reduced display with black
screen and backlighting when a
button is pressed.
Press Minus or Plus to select
1
the desired backlight.
To confirm and move to the
2
next setting, press OK. To exit
user settings, press M for 3
seconds.
17
Adjusting the backlight
Returning to factory settings
1
FR9011480-90-500B-03-22
Holidays
2