Table of Contents
Advertisement
Position the right tractor (as seen from the rear of the printer). Push the right
5.
locking lever down to secure the tractor. Center the middle forms support.
Cut sheet stand
Forms
tractors
Locking levers
Tractor guide
Adjusting the left margin
Below the right tractor, as seen from the back, there is a tractor guide, short inch-
based ruler graduated in 10 columns per inch. Use the ruler to help position the trac-
tor. When the paper edge is positioned to the left most line, the left margin is approx-
imately 12 mm (0.5 inch) including perforation area.
Tractor paper holders
Fit the paper feed holes onto the left and right tractor pins. Adjust the left tractor
6.
(as seen from the rear of the printer) to the width of the form. Close the paper
holders.
Pull the left tractor (as seen from the rear) to stretch the paper taut. Push the left
7.
locking lever down to secure the tractor in place.
Paper select lever
Positioning the tractors
Tractor paper holders
Ajusting the left margin
Paper Handling
Continuous
forms side
3-13
Advertisement
Table of Contents
