Forms Category; Length (Lines); Length (Inches); Lpi - TallyGenicom T6212 Operator's Manual

Forms Category

This category is used for setting form specifics.

Length (lines)

If you wish to define the length of your form in lines, you may select a form
length from 1 to 255. The default option is 66.

Length (inches)

If you wish to define the length of your form in inches, you may select a form
length from 0.1 to 25.5 inches. The default option is 11.0 inches.

LPI

This allows you to set the lines per inch. The possible selections are 1.5, 2, 3,
4, 5, 6, 8, 9, 10, and 12. The default setting is 6 LPI.

Top Margin

This parameter dictates where the first print line is located on the page. The
Top Margin location is measured in lines from the current Top-of-Form location.
The range is 0 to 255, with the default at 0.
IPDS
In the IPDS emulation, the value set in this category is not used, since the
value is set up in the data stream.

Bottom Margin

This parameter allows you to set the bottom margin. The Bottom Margin is
measured in lines from the current Top-of-Form location. The range is 0 to 255,
with the default at 66.
IPDS
In the IPDS emulation, the value set in this category is not used, since the
value is set up in the data stream.
The Bottom Margin and Top Margin selections are translated into a
physical location on the page. Subsequent changes in LPI affect this
location. If the new location does not exactly correspond with a line
position, no asterisk is shown as a "current setting" indicator.
For example:
The initial Bottom Margin selection was line 60 and the current LPI was 6.
The Bottom Margin location would be 10 inches from the Top-of-Form location.
If the LPI was then changed to 10 LPI the selection for Bottom Margin would
change to line 100.

Left Margin

You can place the left margin at any column number across the page, using
selections 1 to 272. The range of selections for this parameter depends on the
CPI setting. (Column 1 is the Default). The left margin must be less than or
equal to the right margin.
Chapter 3: Printer Menus and Configuring Your Printer
3–9