Table of Contents
Advertisement
en Troubleshooting
Fault
Appliance is not heat-
ing; the colon flashes
in the display.
The appliance door
cannot be opened;
lights up in the dis-
play.
The appliance door
cannot be opened;
lights up in the dis-
play.
The time flashes in
the display.
The time does not ap-
pear in the display
when the appliance is
switched off.
lights up in the dis-
play and no settings
can be made on the
appliance.
flashes in the dis-
play and the appli-
ance will not start.
appears in the
display.
A message with ap-
pears in the display,
e.g.
-
.
24
Cause and troubleshooting
Demo mode is activated.
1.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
the fuse box off and back on again.
2.
Deactivate demo mode within five minutes by changing the basic setting to .
→ "Basic settings", Page 15
The childproof lock locks the appliance door.
▶
Use the button to deactivate the childproof lock.
→ "Childproof lock", Page 15
The cleaning function locks the appliance door.
▶
Allow the appliance to cool down until
→ "Self-cleaning ", Page 18
There has been a power cut.
▶
Reset the time.
The basic setting has been changed.
▶
Change the basic setting for the time display.
→ "Basic settings", Page 15
Childproof lock is activated.
▶
Use the button to deactivate the childproof lock.
→ "Childproof lock", Page 15
The cooking compartment is too hot for the selected operation.
1.
Switch off the appliance and allow it to cool down.
2.
Restart the operation.
The maximum cooking time has been reached. To prevent an unwanted permanent opera-
tion, the appliance automatically stops heating after several hours if the settings are un-
changed.
▶
Switch off the appliance.
You can configure new settings if required.
Tip: To prevent the appliance from switching off when you do not want it to, e.g. for an
extremely long preparation time, set a cooking time.
→ "Time-setting options", Page 11
Electronics fault
1.
Press the
button.
If required, reset the time.
‒
a If the fault was a one-off, the error message disappears.
2.
If the error message appears again, call the after-sales service. Quote the exact error
message and the E no. of your appliance.
→ "Customer Service", Page 25
goes out in the display.
Advertisement
Table of Contents
