Table of Contents
Advertisement
en Cleaning and servicing
Display
Basic setting
Automatic rapid heating from 200 °C
Reset all values to factory settings
1
Factory setting (may vary according to model)
2
Depending on the appliance specifications
12.2 Changing basic settings
Requirement: The appliance is switched off.
1.
Press and hold the
four seconds.
a The first basic setting appears in the display, e.g.
.
2.
Use the
or
button to change the setting.
3.
Use the
button to switch to the next basic setting.
13 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
13.1 Cleaning products
In order to avoid damaging the various oven surfaces
on the appliance, do not use unsuitable cleaning
products.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶
Do not use harsh or abrasive cleaning products.
Suitable cleaning agents
Only use cleaning products that are suitable for the dif-
ferent surfaces on your appliance.
Appliance front
Surface
Suitable cleaning agents Information
Stainless steel
¡ Hot soapy water
¡ Special stainless steel
Plastic or painted
¡ Hot soapy water
surfaces
E.g. control panel
16
button for approximately
cleaning products
suitable for hot sur-
faces
Selection
= No
1
= Yes
1
= No
= Yes
4.
To save the changes, press and hold the
for approx. four seconds.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
12.3 Discarding changes to the basic
settings
▶
Touch
a All changes are discarded and not saved.
▶
Do not use cleaning products with a high alcohol
content.
▶
Do not use hard scouring pads or cleaning
sponges.
▶
Do not use any special cleaners for cleaning the ap-
pliance while it is hot.
Using oven cleaner in a hot cooking compartment
damages the enamel.
▶
Never use oven cleaner in the cooking compartment
when it is still warm.
▶
Remove all food remnants from the cooking com-
partment and the appliance door before you next
heat up the appliance.
New sponge cloths contain residues from production.
▶
Wash new sponge cloths thoroughly before use.
Follow the instructions on cleaning the appliance.
→ "Cleaning the appliance", Page 17
To prevent corrosion, remove any patches of limescale, grease,
starch or albumin (e.g. egg white) on stainless steel surfaces imme-
diately.
Apply a thin layer of the stainless steel cleaning product with a soft
cloth.
Do not use glass cleaner or a glass scraper.
.
button
Advertisement
Table of Contents
