Vertical Beaters - H&S 4142 Operator's Manual

BEATER REMOVAL
The beater attachment can easily be removed for various
reasons such as manure stock piling. Remove bolts, nuts
and lockwashers (A). Remove connector link on chain (B).
Strip chain from sprockets. Set bolts and chain aside.
Securely attach a lifting chain to lifting eyes at the top of
the beater assembly (C). Lift beater assembly gently until
alignment pegs are clear of the alignment holes (D).
BEATER STORAGE
After the beater assembly has been removed make
sure the legs are securely bolted in place (E).
The beater assembly must be stored on a flat
level concrete surface.
CLEAN OUT PAN
The clean out pan should be used at the end of each day or between each load during freezing weather.
To trip the pan, pull forward on lever (F). The pan (G) will drop and allow the manure build up to fall to the
ground. Note: The endgate should be completely raised and the push gate fully extended (All the way
to the rear of the spreader). To reset the clean out pan, lift up on handle (H).

VERTICAL BEATERS

C
D
F
A
B
A
E
H
-23-
Shields Removed for Clairty
G