Advertisement
SAFETY INFORMATION
SAFETY SYMBOLS
This is the safety alert symbol. When you see this symbol on
your pump or in this manual, look for one of the following signal
words and be alert to the potential for personal injury:
warns about hazards that will cause serious
DANGER
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause minor
personal injury or property damage if ignored.
The word NOTICE: indicates special instructions that are
important but not related to hazards.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
GENERAL SAFETY
Do not touch an operating motor. Modern
motors can operate at high temperatures. To avoid burns
when servicing pump, allow it to cool for 30 minutes after
shutdown before handling.
Follow all applicable local and state codes and regulations.
Submersible pumps are not approved for and should not be
used in swimming pools, recreational water installations,
decorative fountains or any installation where human
contact with the pump fluid is common. Pump is designed
for municipal and commercial wastewater applications.
Keep safety labels in good condition, replacing any missing
or damaged labels.
DO NOT run the pump dry. Dry running can overheat the
pump, (causing burns to anyone handling it) and will void the
warranty.
The pump is permanently lubricated. No oiling or greasing is
required in normal operation.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted.
Store all unused tools and equipment.
DO NOT use to pump flammable liquids.
RISK OF FIRE OR EXPLOSION. Can cause
severe personal injury, property damage or death. Do not
smoke or use open flames in or around this system.
E-03-600 (07-15-22)
CUTTING RISK. Risk of serious cutting or
amputation exists. Use caution as liner plate is extremely
sharp. Always keep fingers and hands away from cutting
profiles. Disconnect all power sources prior to servicing
pump. Pump may start without warning.
RISK OF ASPHYXIATION. Installer(s) and/or
service personnel must use proper Personal Protective
Equipment and follow OSHA 29 CFR 1910.146 or OSHA 29
CFR 1926. Pump may be installed in a location classified as a
confined space.
BIOHAZARD RISK. Once wastewater source
has been connected to system, Biohazard Risk exists.
Installer(s) and/or service personnel must use proper
personal Protective Equipment and follow handling
procedures per OSHA 29 CFR 1910.1030 when handling
equipment after wastewater source has been connected to
system.
NOTICE: FM rated models are only to be used in 60hz
applications.
ELECTRICAL SAFETY
Hazardous voltage. Can shock, burn, or kill.
When installing, operating, or servicing this pump, follow the
safety instructions listed below.
ELECTROCUTION HAZARD: Must be installed
by a qualified professional. Disconnect all electrical power
before attempting service.
DO NOT modify the cord. When wiring to a system control,
connect ground lead to the system ground.
DO NOT splice the electrical power cord.
DO NOT allow the power leads on the end of the electrical
cords to be submerged.
DO NOT handle or service the pump while it is connected
tothe power supply.
A water test must be taken before installation
of any water treatment equipment. The water quality can
significantly influence the life of your system. You should
test for corrosive elements, acidity, total solids and other
relevant contaminants, including chlorine and treat your water
appropriately to ensure satisfactory performance and prevent
premature failure.
3
Advertisement
