Table of Contents
Advertisement
Quick Links
MODEL HPGB750/1000/1500 and
HPGBX750/1000/1500
SUBMERSIBLE
GRINDER PUMPS
INSTALLATION AND SERVICE MANUAL
For use in hazardous locations with FM approved Class I, Division 1, Groups C & D.
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Item # E-03-617 | Part # 23833A617 | © 2018 Pentair plc | 05/18/18
Advertisement
Table of Contents
Related Manuals for Pentair HYDROMATIC HPGB750
Summary of Contents for Pentair HYDROMATIC HPGB750
- Page 1 NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Item # E-03-617 | Part # 23833A617 | © 2018 Pentair plc | 05/18/18...
- Page 2 CAUTION: Read these safety 9. Only pumps labeled for use in General Information warnings first before installing, hazardous location may be used servicing, or operating any pump. in hazardous locations. These IMPORTANT: Hydromatic ® is not Only qualified persons shall conduct motors must be repaired and responsible for losses, injury or death services and installations of this...
- Page 3 General Installation: If the measured values are below The float level controls maintain the specification, the pump may have a basin sewage water level by controlling Various configurations and methods of lower seal failure and require service. pump turn-on and turn-off levels. plumbing this series of solids handling pumps may be used;...
- Page 4 To Re-wire the pump from 230V to Readings should be taken with 9. If above checks do not locate 460V 3 phase: Only a 230V pump from line leads disconnected from the trouble, motor rotor may be loose the factory is considered dual voltage, control panel.
- Page 5 SENSOR LEADS WHITE W/BLACK STRIP - P1 BLUE - P2 ORANGE - SEAL PROBE Circuit breaker trips. MOTOR LEADS 208 - 230V SINGLE PHASE 1. Reset breaker by pushing WHITE BLACK P1 (PURPLE) completely down on handle then P2 (BROWN) back to On position.
- Page 6 HPGB750/1000/1500 and HPGBX750/1000/1500 PARTS LIST Ref. Part Part Qty. Description 35' Cord assembly 05876A119 O-ring HHCS 1/2"-13 UNC x 19103A045 1-3/4" 22873C000 Upper bearing cap 191331A007 Load spring 08565A032 Ball bearing, upper see ch art Rotor/shaft assembly 22874D000 Motor housing see chart Stator 08565A026 Ball bearing, lower HHCS 1/2"-13 UNC x...
- Page 8 Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. Under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.
Need help?
Do you have a question about the HYDROMATIC HPGB750 and is the answer not in the manual?
Questions and answers