Table of Contents
Advertisement
Quick Links
MODEL HPGX200
(Class I, Division 1, Groups C & D): FM
HAZARDOUS LOCATION
SUBMERSIBLE GRINDER PUMP
INSTALLATION AND SERVICE MANUAL
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Item # E-03-438 | Part # 5625-438-1 | © 2018 Pentair plc | 4/16/18
Advertisement
Table of Contents
Related Manuals for Pentair HYDROMATIC HPGX200
Summary of Contents for Pentair HYDROMATIC HPGX200
- Page 1 NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Item # E-03-438 | Part # 5625-438-1 | © 2018 Pentair plc | 4/16/18...
-
Page 2: General Information
CALIFORNIA PROPOSITION panel. The sensors are set to trip General at 120 degrees Cel sius. 65 WARNING: Information This product and NOTE: Failure to install such related accessories contain cir cuit ry would ne gate FM Attention: chemicals known to the approval and all warranties by This manual contains important State of California to cause... - Page 3 it must be broken loose with a and that the pumps are submerged certifications. While prying small bar or screwdriver in edge in a vertical position. The evenly on both sides; separate of vanes. The impeller should turn complete factory-built packaged the cord cap casting from the freely.
-
Page 4: Pump Operations
If cords require replacement due Pump Maintenance Pump Operations to damage or cords being too As the motors are oil filled, no short, cord and cap assembly WARNING: Keep hands and lubrication or other maintenance must be replaced as a complete cloth ing away from cutters is re quired. -
Page 5: Pump Troubleshooting
10. Plug pump into power and 4. Head lower than rating, operate for a few seconds pumping too much liquid only to ensure parts are not 5. Pump clogged rubbing. 6. Defective bearings Replacing Lower Seal, Impeller 7. Defective impeller or Volute: Pump is noisy. -
Page 6: Wiring Diagrams
Wiring Diagrams... - Page 7 HPGX200 Parts List Ref. Part Part Description Qty. 152750325 35' Cord Assembly – 14-4 152750305 35' Cord Assembly – 12-4 152750315 35' Cord Assembly – 10-4 19100A029 Screw – Cap 05876A244 O-Ring 108980001 Connector 077630001 Cutter Retaining Ring 049180001 Lower Seal Seat 054050012 Radial Cutter 05876A120...
- Page 8 Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. Under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.