Table of Contents
Advertisement
SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS: This manual contains important
instructions that should be followed during installation,
operation, and maintenance of the product. Always refer to the
equipment owner's manual for safety information relevant to
that product.
This is the safety alert symbol. When you see this symbol
on your product or in this manual, look for one of the following
signal words and be alert to the potential for personal injury!
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
indicates a hazard which, if not avoided, could
result in minor or moderate injury.
The word NOTE indicates special instructions that are important
but not related to hazards.
GENERAL SAFETY
Carefully read and follow all safety instructions in this
manual and on product.
Keep safety labels in good condition. Replace missing
or damaged safety labels.
When running centrifugal pumps, it is essential that
operators use hearing protection as the sound levels can
reach levels of 80 decibels.
When handling pumps, wear steel-toed shoes and
protective gloves in order to protect the feet in the event
the pump is dropped and protect the hands from any sharp
surfaces on the pump or chemicals. If the pump is being
repaired while the pump is in service, eye protection should
also be worn.
4
Only authorized operators having the knowledge and
skill necessary to safely use a pump, or any equipment the
pump is connected to, may run the pump.
When spraying manually, it is recommended that
chemical-resistant face masks and clothing be worn to
prevent any chemicals from coming into contact with the
skin or being inhaled.
When spraying manually, always spray upwind of
yourself as long as the sprayed chemical will not drift into
the vicinity of other people.
When installing, adjusting or removing a pump, ensure
that there are no objects which can fall on the installer and
that all attached machinery is turned off.
Never operate a pump outside while there is a chance
of getting struck by lightning.
Never leave electrical wires or plumbing components
where they can be a tripping hazard or become entangled
in a moving component. Ideally, electrical cables, hoses,
pipes and fittings should be routed overhead. In the event
electrical wiring must be routed over the ground, operators
are required to use rubber ramps if they cross a gangway.
Pumps should not be used if the ambient light is below
200lux.
Only use approved chemicals in your pump. For a
complete list of approved chemicals, see the "Fluid
Pumping Applications" section. Failure to follow this
warning will void your warranty and could lead to
property damage, serious injury or death.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.
L-1578 (08-15-2023)
Advertisement
Table of Contents
