Pentair STA-RITE HMS-1FL Series Owner's Manual
Pentair STA-RITE HMS-1FL Series Owner's Manual

Pentair STA-RITE HMS-1FL Series Owner's Manual

Horizontal multi-stage jet pumps

Advertisement

OWNERS MANUAL
Horizontal Multi-Stage Jet Pumps
"HMS-1FL" Series
MODELS
3/4 HP
1 HP
1-1/2 HP
HMSD-1FL
HMSE-1FL
HMSF-1FL
293 WRIGHT STREET, DELAVAN, WI 53115 WWW.STA-RITE.COM
PH: 888-782-7483
S1002 (11/07/12)
© 2012 Pentair, Inc. All Rights Reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STA-RITE HMS-1FL Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Pentair STA-RITE HMS-1FL Series

  • Page 1 OWNERS MANUAL Horizontal Multi-Stage Jet Pumps “HMS-1FL” Series MODELS 3/4 HP 1 HP 1-1/2 HP HMSD-1FL HMSE-1FL HMSF-1FL 293 WRIGHT STREET, DELAVAN, WI 53115 WWW.STA-RITE.COM PH: 888-782-7483 S1002 (11/07/12) © 2012 Pentair, Inc. All Rights Reserved.
  • Page 2: California Proposition 65 Warning

    California Proposition 65 Warning Close regulator adjusting valve, located on end of regulator, by turning stem clockwise. See Figure 1. This product and related accessories con- Remove priming plug from top of regulator valve. Fill with tain chemicals known to the State of California to cause clean water.
  • Page 3 To Service Never run pump against closed discharge. Priming Plug & To do so can boil water inside pump, causing hazardous 1/2" Street Elbow pressure in unit, risk of explosion and possibly scalding per- sons handling pump. To prime the pump, completely open the priming valve locat- ed just below the suction opening on the tank body by turning 1"...
  • Page 4 Electrical Disconnect power before working on pump, motor, pressure switch, or wiring. MOTOR SWITCH SETTINGS Your motor terminal board (located under the motor end cover) should look like one of those below. If the motor can operate at either 115 or 230 volts, it is set at the factory to 230 volts. Do not change motor wiring if line voltage is 230 volts, or if you have a single voltage motor.
  • Page 5: Limited Warranty

    Connection Procedure: Hazardous voltage. Can shock, burn, or kill. Connect ground wire before connecting power sup- 1. Connect the ground wire first as shown in Figure 4. The ply wires. Use the wire size (including the ground wire) ground wire must be a solid copper wire at least as large specified in the wiring chart.
  • Page 6: Exploded View

    EXPLODED VIEW...
  • Page 7: Repair Parts

    REPAIR PARTS PART HMSD-1FL HMSE-1FL HMSF-1FL DESCRIPTION W/KIT USED 3/4 HP 1 HP 1-1/2 HP Motor, 60 Hz, 115/230V - Single Phase A700DH A700EH A700FH •1A Key - Shaft U65-15SS U65-15SS U65-15SS Water Slinger 17351-0009 17351-0009 17351-0009 Capscrew - 3/8” x 16 x 1” Hex Head U30-74ZP U30-74ZP U30-74ZP...
  • Page 8 J212-24H Regulator Valve EXPLODED VIEW 229 1093 REPAIR PARTS PART PART DESCRIPTION QTY. NUMBER Pressure Regulator – Complete Pkg. 107 Regulator Body w/Seat J112-14 Seat J66-16 Diaphragm Assembly w/Guide (Incl. 2A, 2B) J220-16B Guide J42-5 Diaphragm Assembly (Incl. 2C, 2D, 2E, 2F, 2G) J120-16 Stem J62-9...

This manual is also suitable for:

Sta-rite hmsd-1flSta-rite hmse-1flSta-rite hmsf-1fl

Table of Contents