Service Interval Display: Recoding - Volkswagen Passat 2015 Manual

Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
Maintenance - Edition 11.2020
Inspection service interval display: resetting
With function button on dash panel insert
– With ignition switched off, press and hold button -1-.
– Switch on ignition.
Wait until "Reset inspection?" appears on the display. on the
display.
– Release button -1-.
The service interval display is now in the resetting mode.
– Briefly press button -1- once.
After a short time the display switches back to the original dis‐
play.
4.60

Service interval display: recoding

Note
If the display is not as shown in the procedure: ⇒ Operating
instructions for vehicle diagnostic tester
Recoding from flexible to fixed intervals
– Connect vehicle diagnostic tester
– Switch on ignition.
– Carry out identification of vehicle.
– Enter task data, or select "Without task".
– Select "Control units".
– Select "Dash panel insert".
– Select "Guided Functions".
– Select "Change flexible/fixed intervals".
– Carry out adaptation according to the information of "Guided functions".
Changing values for maximum distance to be driven (km) until
next oil change service (fixed) during delivery inspection
– Connect vehicle diagnostic tester
– Switch on ignition.
– Carry out identification of vehicle.
186
4. Descriptions of work
ODIS Service
⇒ page 30 .
ODIS Service
⇒ page 30 .