Passat 2015 ➤, Passat 2019 ➤, Passat Variant 2015 ➤, Passat Variant 2019 ➤
– For calibration of the main beam, »VW Seg« must be selec‐
ted on the headlight adjustment unit -VAS 621 001-.
– Transfer measured values for both headlights in angular mi‐
nutes (note algebraic signs) to vehicle diagnostic tester.
This concludes the adjustment process.
4.56
Headlight adjustment: checking fog
lights
Note
Additional weights are no longer used.
♦
Instead, a different inclination setting on the headlight adjust‐
♦
ment unit is used.
If the maintenance tables are used, the settings are dis‐
♦
played in the vehicle-specific maintenance list.
The headlight adjustment is subject to a separate charge.
♦
Test and adjustment conditions
Check headlight adjustment
Adjusting fog lights and other additional lights
4.56.1
Test and adjustment conditions
•
Tyre pressure OK
•
Lenses must not be damaged or dirty.
•
Reflectors and bulbs OK.
•
The vehicle must be rolled forward and backward several
metres or front and rear springs must be bounced fully sev‐
eral times so that springs settle.
•
Vehicle and headlight adjuster must be on a level surface.
•
Vehicle and headlight adjuster must be aligned.
•
Inclination must be set.
•
Refer to the ⇒ operating instructions for headlight adjust‐
ment units.
•
The current software for the headlight adjustment unit -VAS
621 001- is available on the equipment manufacturer's
homepage.
⇒ page 181
⇒ page 182
.
⇒ page 182
Maintenance - Edition 11.2020
.
181
4. Descriptions of work